Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - saroj007

Pages: [1]
1
Mitel MiVoice Business/MCD/3300 / Re: g722 codec
« on: September 27, 2017, 04:06:44 AM »
Thanks @acejavelin for the quick response. Actually its a SIP trunk. And I am trying to execute the scenario where I have to make an outbound call and codec G722 should be getting negotiated but whenever I am making an outbound call by enabling the g722 codec from codec list ,the invite from PBX does not have the payload type for g722.

If its not supported for a sip trunk, could you please send me any reference document from Mitel that mentioned the same.
I Appreciate your support...

Regards
Saroj

2
Mitel MiVoice Business/MCD/3300 / g722 codec
« on: September 26, 2017, 03:47:01 AM »
HI All ,
Does mitel 3300 support codec g722. In codec list i can see both codecs are avilable .I turned the g722.1codec on from mitel PBX by selecting "no" and i can see the outbound invite contains payload type "102" which is for g722.1 .(its only working for mitel IP phone 5330 and 5360) but when i turned the g722 codec from the codec list by selecting "no" to the specific codec , the PBX should send the invite with g722 codec for the outbound call but this is not happening.

Is g722 is a supported codec for mitel 3300 if yes how can i enable it.

3
Mitel MiVoice Business/MCD/3300 / telewalker configuration
« on: September 12, 2017, 03:27:44 AM »
Hi,
I am trying to configure a telewalker phone to mitel MBG . I have assigned a public ip to the phone but the phone is not registered yet.i have used the below configuration to the mitel 5312 phone and from phone .MBG wan IP is pinging .but phone is not registering its pop up en error messages " CONNECTION REFUSED" CONTACT TW ADMIN.Please let meknow if i have missed any configuration .
the phone i have configured is like below..

Phone IP address : Public IP
Def GW IP : the gateway IP for Public IP
Subnet mask : the subnet mask for public ip
ICP IP address : Didn't gave anything
TFTP SVR IP : Didn't gave anything
TFTP SVR port :5060
IPA IP Address : Didn't gave anything
DNS1 IP Address : Gave the actual DNP IP
DNS2 IP address : Didn't gave anything
then did the ping test with MBG WAN IP it was pinging then i have save and restore the configuration.
Config Teleworker Gateway : MBG WAN IP ) (under phone mode or pressing 7 during reboot of phone) 

Please let me know if i missed anything to work this.



Pages: [1]