Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cschwartz

Pages: [1]
1
SIP On Mitel / Re: Configure UC360 for SIP
« on: January 24, 2017, 09:09:31 AM »
Only had it connected to micloud for a couple of months then unused for several months.  When I switched to asterisk and plugged it in red icon. I was hoping that it was user error rather than faulty device.  Is there any place to send it for repair other than mitel?

2
SIP On Mitel / Re: Configure UC360 for SIP
« on: January 23, 2017, 07:00:15 PM »
Quote from: johnp on January 20, 2017, 07:53:54 PM
Did you try a static address? can you ping it?
I did try setting a static address.  No love.  I have not been able to ping either to or from the device. 

3
SIP On Mitel / Re: Configure UC360 for SIP
« on: January 20, 2017, 06:56:58 PM »
The issue is that there's a red icon in the upper right indicating that the device is disconnected from the network.  When plugged into an ethernet cable that I am certain works, I can't see it from our router and a ping from the device to 8.8.8.8 fails.

4
SIP On Mitel / Re: Configure UC360 for SIP
« on: January 20, 2017, 11:50:38 AM »
I have configured everything I recognize.  Not certain that it's all correct.

5
SIP On Mitel / Re: Configure UC360 for SIP
« on: January 20, 2017, 08:53:13 AM »
Hey Guys... I've been struggling with this darn UC360 for a couple of months now.  Plug it in, it powers up, works fine, just won't connect to the network.  I've done a factory reset, still no connection.  If anyone has experience with this device and can help, my contact information is below.  Obviously, (or maybe not so obviously) We are willing to pay for support.  (it's 7 am as I post this.  Please don't call until 9 am)

Corey Schwartz
8520 East Shea Blvd #115, Scottsdale, AZ 85260
www.loanatik.com

Corey Schwartz
480-588-0397
cschwartz@Loanatik.com

6
SIP On Mitel / Configure UC360 for SIP
« on: December 02, 2016, 01:00:24 PM »
I picked up a mitel UC360 to use on an Asterisk system.  I can't seem to get the UC360 properly configured.  When I try a ping test from the device to any address it fails.  Are there any guides to configuring this phone on Asterisk?

Pages: [1]