Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cpomplun

Pages: [1]
1
Mitel MiVoice Business/MCD/3300 / Re: Mitel To Telecor Paging System
« on: November 22, 2016, 09:16:05 AM »
I checked the Circuit and the Fake Answer Supervision After Outpulsing is Yes, I changed it to no and tested, the long delay was longer, so I changed it back to No....Any other ideas?

2
Mitel MiVoice Business/MCD/3300 / Re: Mitel To Telecor Paging System
« on: November 21, 2016, 02:24:22 PM »
If you're using an ARS route, check the circ descriptor of the LS port and be sure that it's not waiting for answer supervision before cutting through the audio.

Ralph

Let's pretend for a moment that I don't know what 'circ' means or where I would find that setting... :P 
I have two 3300s, one connects to a paging unit in the High School and the other 3300 connects to one in our Elementary School (The one with the problem) I've been trying to find what setting is different between the two, but I can't seem to find it, I probably just don't know where to look!

3
Mitel MiVoice Business/MCD/3300 / Re: Mitel To Telecor Paging System
« on: November 21, 2016, 01:26:23 PM »
The paging system isn't actually connected to the Paging port, it's just on an LS port on the back.

4
Mitel MiVoice Business/MCD/3300 / Mitel To Telecor Paging System
« on: November 21, 2016, 12:35:44 PM »
Hi all,

I have a Mitel 3300 connected via an analog port to a Telecor paging system, it take around 4-5 seconds for my voice to sound after the initial beep beep of the telecor system.  My question to the group is this: is there a time delay or delay setting for an analog port before your voice can be heard?

I hope someone can help!  Thanks!

Pages: [1]