Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - happer

Pages: [1]
1
Mitel Software Applications / Re: Cannot Automate Contact Center Client install due to Chocolatey problems
« on: November 07, 2016, 02:46:24 PM »

Sounds like you may have forgot to re-run the RedisPacker after you did the manual steps 3 and 4 you listed in your reply.
If you don't re-run the redisPacker then it won't rebuild CCP and you will be running the CCP with the issue present.
Rebuilding this will give you a good CCP so that you won' t have the issue on every box.
Here are the steps I'm referring to.
Sarond is correct that this was fixed in the 8.1 load and re-posted so you won't see this

5. Browse to the CCM\PFInstaller folder in a command prompt and run "Micc.RedistPacker.exe /repackCCP" (without quotes).
     NOTE: The Command prompt will go to the next line immediately.  The MiCC.RedisPacker process can take up to 30 minutes to complete.  It will be visible in your system tray, and task manager until done.
6. This will fix the CCP, and installation on clients that download the CCP going forward should not experience this issue.



2
Mitel Software Applications / Re: Cannot Automate Contact Center Client install due to Chocolatey problems
« on: October 06, 2016, 04:48:17 PM »
This issue is fixed in 8.1.0.0 load.
If you are unable to install the 8.1.0.0 load then you can eliminate your problem with the clients you are describing by following the updated kb article
http://micc.mitel.com/kb/KnowledgebaseArticle52481.aspx (pay special attention to the section talking about the Client Component Pack.  This will solve your first issue with the vs 2010 resdist error.

In regards to MSI's. No Mitel does not produce an MSI anymore.  You can do everything with a simple exe that you can do with bloated installshield technology.

The command:
setup.exe /silent /enterpriseip="<server ip>"  /features=Ignite,ContactCenterClient,FlexibleReporting,ContactCenterSoftphone,MivoiceBorderGatewayConnector,SalesforceConnector /workflow="Client Component Pack.deploy"

should work (assuming you replaced the server IP of course) as I tested it and it worked fine for me on a Win 7 image.
Here is an excellent kb article to help you with any options you might have questions about http://micc.mitel.com/kb/KnowledgebaseArticle52335.aspx
Cheers!

Pages: [1]