Show Posts
1
Mitel MiVoice Business/MCD/3300 / Mitel MXe with MCD7 - Analog busy after upgrade
« on: May 01, 2015, 02:46:51 PM »
Hello everyone,
I have not had a problem with our 3300 in a long time, and was trained on an old ver (ver 5). Last week I upgraded the system from MCD 6 to MCD 7, and since then, calling out on our analog trunks is not working. I keep getting an error after the number dialed stating "analog BUSY" on the set display. The lines are perfectly fine, and I have rebooted the switch. 13.0.1.53 is the currect active load... .are there any problems like this with this build? I tried the help files, and they came back as MCD 6.2
As part 2 to this question, how can I revert back to the inactive software (ver 12) to confirm its a build issue?
Any help would be greatly appreciated.
Troy
I have not had a problem with our 3300 in a long time, and was trained on an old ver (ver 5). Last week I upgraded the system from MCD 6 to MCD 7, and since then, calling out on our analog trunks is not working. I keep getting an error after the number dialed stating "analog BUSY" on the set display. The lines are perfectly fine, and I have rebooted the switch. 13.0.1.53 is the currect active load... .are there any problems like this with this build? I tried the help files, and they came back as MCD 6.2
As part 2 to this question, how can I revert back to the inactive software (ver 12) to confirm its a build issue?
Any help would be greatly appreciated.
Troy