Messages

1

Mitel SX200, SX2000, and older SX platforms / Re: SX200ICP enable/disable maintenance port

« on: January 08, 2015, 01:02:10 PM »

Thanks everyone!  When I reset the controller I don't see any output in Hyperterminal.  When I have a chance I will try different computer's serial connections, double check the port settings (no flow control, 9600, etc) and CTR-Q.

2

Mitel SX200, SX2000, and older SX platforms / Re: SX200ICP enable/disable maintenance port

« on: January 05, 2015, 04:04:28 PM »

Thanks for your reply.  I don't have access to the device at the minute but I cycled the power and the status was unchanged.  I assume this would clear the X-off?  Any idea if this port can be enabled/disabled outright?

3

Mitel SX200, SX2000, and older SX platforms / SX200ICP enable/disable maintenance port

« on: January 05, 2015, 12:56:46 PM »

Greetings, is there a way to enable/disable the maintenance COM port?  I am able to connect via the web interface
but not the maintenance port.  I am well familiar with serial connections and have double checked the COM settings.
I think the installer may have disabled it.  I am also able to use the SMDR port just fine.