Messages

1

Mitel MiVoice Business/MCD/3300 / Arp error on 3300

« on: July 27, 2016, 09:28:00 AM »

monitoring a 3300 on boot up through the maint. port I saw this error pop up several times        0x3d8fec0 (tNetTask): arptnew failed on 0   Does anyone know what it actually means and how to fix the issue?

2

Mitel MiVoice Business/MCD/3300 / 3300 running 7.1 pr2 Dropping calls after 2mi 54 seconds

« on: November 19, 2015, 10:12:22 AM »

After an upgrade from 6.0 to 7.1pr2 the system is dropping outbound calls only after 2 min and 54 seconds into the call and the display says "Timeout" and you hear reorder tone, This is a clusterd envirement with 3 mxe3 controllers The main controller which houses the pri's is having no issues as well as the second mxe3 contorller. only one site is having this issue. Internal calls are fine. Call duration in the cos of the phones,ip trunking and pri's is not active.

3

Mitel SX200, SX2000, and older SX platforms / Re: sx2000 PRI sending a 1 in fornt of international calls

« on: November 04, 2015, 02:39:14 PM »

It is not in the digit mod tables the 1 is being inserted Via the IMAT software. Already tested that ( I thought the same thing at first)

4

Mitel SX200, SX2000, and older SX platforms / sx2000 PRI sending a 1 in fornt of international calls

« on: November 04, 2015, 10:54:30 AM »

I have a sip based pri from AT&T connected to a sx 2000 Pri card in a dsu node. It is set for NI2 Belcore. On international calls we are sending a 1 and the carrier is rejecting the call. I tried to change the enable unknown ton/np but that made no difference. I changed the protocall variant from belcore to 5ess and it added two 1's in front of international calls. Any help on this problem would be greatly appreciated. AT&T is not helping in this issue.

5

Mitel SX200, SX2000, and older SX platforms / Print cmd for sx2000 to the screen

« on: December 06, 2013, 11:40:44 AM »

I am looking for the cmd to print to the screen on a sx2000

6

Mitel MiVoice Business/MCD/3300 / Re: MCD 5.0 Internet explorer 11 or Mozilla Firefox

« on: December 06, 2013, 11:26:46 AM »

Some of our techs are running IE11 and the only issue they had was having to run it compatibility mode. We tested it on MCD 6.0 sp1