Show Posts
1
MiVoice Office 250/Mitel 5000 / Office 250 - Sys Admin & Diag - DB Programming UI not visible
« on: June 30, 2021, 12:31:04 PM »
I am new to Office 250 and faced with some challenges with Licensing the HX Controller.
I understand a dedicated PC Win10 is needed to control the HX Controller.
MCS and Sys Admin & Diag are the tools installed. I already used MCS to enter Site and License information and it is stored but not pushed to the HX.
I need to push somehow to the HX.
I have installed 6_3_102_0-SysAd_6_3_9_102-DBP-64bit but run into trouble. The tool can connect to the HX but when I select the "Launch DB Programming" no UI GUI shows up. What could be causing this?
I understand a dedicated PC Win10 is needed to control the HX Controller.
MCS and Sys Admin & Diag are the tools installed. I already used MCS to enter Site and License information and it is stored but not pushed to the HX.
I need to push somehow to the HX.
I have installed 6_3_102_0-SysAd_6_3_9_102-DBP-64bit but run into trouble. The tool can connect to the HX but when I select the "Launch DB Programming" no UI GUI shows up. What could be causing this?