Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - hunter

Pages: [1]
1
Mitel MiVoice Business/MCD/3300 / ICP3300 MX Controller
« on: September 07, 2023, 12:40:46 PM »
Hi Guys, have an old MX Controller working on Rel9.1 (old Release 9.1). Need Amphenol connector wiring diagram at the back of the controller. Does anyone has an old hardware manual or technician handbook of such release???

2
Hi guys, any chance of one of you has a sample technical specifications for MiVB systems and IP phones? Mitel's sample specs "Proposal for MiVB" is just scrap. We need to get prepared for some competitive tenders and willing to feed in prospect customers with our sample tender specificatins. Any help will be appreciated, cheers.

3
Hi All, tried to manual load of MiVB9.3 SW onto blank 16GB CF on AX Controller. Configured MS IIS and tftpd64 TFTP server as per Technician Handbook but it fails after formatting the CF, giving error about some ax image file not found. Guess IIS and tftpd64 configs, as given in tTech Handbook were not working properly. Anyone having this experience?

4
Hi guys, could not find the u-boot config to manual load MiVB 9.1 or later SW to an AX Controller with blank 16GB CF. Anyone has a hint on if we should add some line to U-Boot something like earlier FixPartition?

5
Mitel MiVoice Business/MCD/3300 / "Memory Used" problem on MXeIII
« on: August 31, 2020, 01:00:06 PM »
Hi Guys, Have quite long experience on MCD and MiVoice Business but have a trouble first time so exciting. Appreciate any help and ideas; Have a standalone MCD5.0 system working on MXeIII with 512 MB RAM and expansion kit, i.e. both RTC and E2T cards (as they were exactly the same). System started to raise "Memory Used" alarm after 8 years of very stable operation. It starts with Minor alarm, 2 hours later Major Alarm, couple of more minutes Critical alarm and immediate reset. This cycle goes on every 4 - 5 hours. Same SW load of 11.0.2.66 loaded  and restored from recent backup, 512 MB RAM replaced, 2 RAID HDDs replaced with SSDs, but no way. Memory Used alarm and consequent restarts continue. Any idea / suggestions / former experiences much, very much appreciated.

6
Mitel MiVoice Business/MCD/3300 / SIP Trunk issue with DT
« on: January 16, 2019, 09:41:07 AM »
Hi All,

We have a Mitel MiVoice Business installation in Macedonia and it uses SIP trunk to local telco. All are OK except outgoing international call setup. Local Telco delivers all international outgoing call requests to Deutsche Telecom (without further handling). DT immediately sends a "400 Bad Request" message and clears the call. Local Telco says that DT does not support G729 and ask us to restrict SIP Trunk codec setting to G711 a / u only. We did and nothing changed. Seems that some other parameter in SDP Options etc causes the issue. Does anybody have any idea please?

Regards,

7
Mitel MiVoice Business/MCD/3300 / Mitel 5624 VoWiFi Registration problem?
« on: February 17, 2013, 03:30:21 PM »
Hi All, trying to setup Mitel 5624 WiFi phones to Mitel 3300 MCD 5.2. Firmware of 5624s is3.4.10. They register to the WiFi network, but cannot register to the Mitel 3300 CX controller. Anybody has experience on 5624 please?

Pages: [1]