Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: brogerson on October 27, 2016, 09:26:55 AM

Title: DSP Alarm on MXeIII
Post by: brogerson on October 27, 2016, 09:26:55 AM

I just put in a new MXe III at a site with 90 IP Phones, 111 Mailboxes with and Embedded PRI card.  I have a minor DSP alarm telling me I have 5 DSP's and one is unavailable.

The DSP Status maintenance command shows there are 4 DPS and all are available,  I believe the PRI has a DSP which could be causing the alarm but I am not sure.

Title: Re: DSP Alarm on MXeIII
Post by: lundah on October 27, 2016, 09:39:25 AM

The controller has 1 built-in DSP module that shows up as slot 7. Compare the "Show Status DSP" with the Hardware Modules form to see which one is not coming up. I normally try a reboot before replacing the bad module, sometimes that takes care of the alarm.

Title: Re: DSP Alarm on MXeIII
Post by: petr.necas on October 27, 2016, 09:58:24 AM

In our CXi demokit we have no SDP modules installed but have 8 Compression licenses, unless we set the number of used Compression licenses to 0, we have minor "DSP status" alarm.

Title: Re: DSP Alarm on MXeIII
Post by: brogerson on October 27, 2016, 01:13:35 PM

The Show Status DSP command shows all four DSP's are available, reboots and Upgrade BootRom have not cleared the Alarm.

There are 8 Compression Licenses but none are in use and there were only three sets in a Compression zone that have been changed back to Default and the compression programming has been cleared.

Title: Re: DSP Alarm on MXeIII
Post by: johnp on October 28, 2016, 05:25:20 PM

There is one dsp on the resilient T1 single framer. At least their used to be from the early days.

Title: Re: DSP Alarm on MXeIII
Post by: brogerson on October 31, 2016, 01:24:22 PM

I believe there is a DSP on the Combo card but this one is a Dual Framer