Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: dg on December 28, 2015, 10:14:27 AM

Title: "Best" ATA for fax machines?
Post by: dg on December 28, 2015, 10:14:27 AM

Good day, folks,

I'm interested in putting several fax machines on our 3300 with ATA's. We tried this before using ports on the analog cards over SIP and it was a miserable failure. However, now we're on a PRI, so I'm fairly certain faxes should work properly. I'm also thinking that ATA's would be more flexible in that I can move them around with existing ethernet ports rather than having to reroute phone wires. What models of ATAs are officially supported for the 3300? Are the Cisco 112/122's covered? Grandstream? Any others? I'd like to hear experiences from folks that are using any ATAs for faxing.

Thanks in advance,
-dg

Title: Re: "Best" ATA for fax machines?
Post by: bluewhite4 on December 28, 2015, 10:17:12 AM

The Mitel branded ATA's, which are MediaTrix units we've had a tone of success with.

Title: Re: "Best" ATA for fax machines?
Post by: acejavelin on December 28, 2015, 05:46:27 PM

Personally, really like the Grandstream units, especially in high-density deployments, but have also successfully used Audiocodes MP-1xx series.

Mitel has a list of tested, approved SIP devices in their SIP Center of Excellence document.

Title: Re: "Best" ATA for fax machines?
Post by: x-man on December 29, 2015, 08:21:11 AM

We use ports on analog card with PRI in UK quite successfully. We also route them down networking quite happily using the correct dongles.