Mitel Forums - The Unofficial Source

Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: Mattmayn on April 28, 2015, 12:12:33 PM

Title: Plane condition alarm
Post by: Mattmayn on April 28, 2015, 12:12:33 PM

Alarm on a 2k that states "Plane Condition active not synchronized to primary" viewed from plane B. System has not switched planes in "at least 3 weeks." How do I resolve this and what causes it? I haven't worked on a 2k in a while and when I did, it wasn't often.

Title: Re: Plane condition alarm
Post by: ralph on April 28, 2015, 01:04:20 PM

I think I would try to simply reboot the inactive plane 1st. 
If that doesn't work then you may want to try and do a busy mate and rts mate.
If that doesn't work then you may want to try and partition the planes and then join them again.
If that doesn't work then you may want to try and reload the software on the inactive plane.

Ralph

commands that may help:  show stat red

Title: Re: Plane condition alarm
Post by: lundah on May 01, 2015, 10:53:07 AM

Quote from: ralph on April 28, 2015, 01:04:20 PM

commands that may help:  show stat red

I think you mean "file stat red".

Title: Re: Plane condition alarm
Post by: ralph on May 01, 2015, 10:59:30 AM

Thanks lundah.
That's what I meant.
I find myself sometimes mixing 2k command with the 3300 which uses a show command.

Ralph