Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: rlafata on September 12, 2014, 02:48:13 PM

Title: Need jumper for Conference module to 5330 IP phone
Post by: rlafata on September 12, 2014, 02:48:13 PM

I am missing the jumper from a 5310 conference module to a 5330 IP phone.  My vendor does not sell this part separately from the module.  Does anyone know where I can just get the jumper?

Title: Re: Need jumper for Conference module to 5330 IP phone
Post by: johnp on September 12, 2014, 08:37:35 PM

I don't think you will find that part

Title: Re: Need jumper for Conference module to 5330 IP phone
Post by: acejavelin on September 13, 2014, 12:37:29 PM

Johnp is correct, that part is not sold separately...

Doesn't it just short the two center pins? A small needle nose and a drop of solder or conductive glue might do the trick.

Title: Re: Need jumper for Conference module to 5330 IP phone
Post by: johnp on September 13, 2014, 01:09:10 PM

Quote from: acejavelin on September 13, 2014, 12:37:29 PM

Doesn't it just short the two center pins? A small needle nose and a drop of solder or conductive glue might do the trick.

I think that is the the jumper for cordless charging. From looking at the install guide, it looks like about a 3 inch cable

Title: Re: Need jumper for Conference module to 5330 IP phone
Post by: marcolive on September 14, 2014, 11:46:21 PM

Some time ago, we found that these connectors are the same used to plug an old CD-ROM drive to a PC sound card.

http://www.circuitspecialists.com/content/76251/10-190-0.jpg

Remember that?

We made a cable using these connectors and were able to make a 5610 work on a 5330. All 4 pins must be connected.