Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: pakman on January 15, 2014, 03:17:40 PM

Title: Half/Full Duplex
Post by: pakman on January 15, 2014, 03:17:40 PM

I've got two phones that when I looked at the config originally were set to half duplex under the Hardware Config section. I changed them to H/Full but when I save the changes and reboot and look at the port settings it only show half. Now the switch is setup to auto negotiate and I know this is working fine as I can plug in another phone and it boots up just fine and when I look at that phones Hardware Config section it shows it's Full Duplex under the LAN settings. Is there anything else I could try or maybe these two phones NICS are just shoot?

thanks,

Title: Re: Half/Full Duplex
Post by: jrg0852 on January 15, 2014, 03:43:50 PM

Try making the phone "Auto" and see if it takes on the hadshake from the POE switch.

Title: Re: Half/Full Duplex
Post by: pakman on January 15, 2014, 03:59:27 PM

The phone is already set to auto for the port negotiation.

Title: Re: Half/Full Duplex
Post by: acejavelin on January 15, 2014, 06:03:46 PM

Did you try to factory default the phone via the menu?

Title: Re: Half/Full Duplex
Post by: pakman on January 16, 2014, 11:35:02 AM

Yes, I tried that.

Title: Re: Half/Full Duplex
Post by: acejavelin on January 16, 2014, 03:11:36 PM

I saw this once... The fix was to flash it to another PBX & version (I have access to lots of different Mitel PBXs, in this case I used a newer 5000 system), then bring it back and let it reflash to the 3300 it was originally for. Otherwise I gotta go with a bad phone.

Title: Re: Half/Full Duplex
Post by: pakman on January 16, 2014, 04:28:57 PM

Thanks for the suggestion, I don't have another version but I will try taking it back and plugging it into another PBX to see what happens. Otherwise that was also my conclusion.

Thanks,