Mitel Forums - The Unofficial Source

Mitel Forums => MiVoice Office 250/Mitel 5000 => Topic started by: canadaed on December 18, 2013, 11:01:36 PM

Title: Caller ID works intermittently
Post by: canadaed on December 18, 2013, 11:01:36 PM

I have installed a Mitel 5000 with loop start trunks. The outside caller ID does not always display on the sets. I have checked all the programming fields that I think relate to this problem. When checking the system logs, I see this message quite often

-01:298- > -01:240- 08:50 17-12 M5020 WRN HW CP [10.1.1]: Caller ID Terminated Due To Connect Timer Expired

Does anyone know if this timer is related to my problem and where it is located? I am new to this product and would appreciate any help.

Title: Re: Caller ID works intermittently
Post by: acejavelin on December 18, 2013, 11:18:21 PM

Are you sure the telco is sending Caller ID on ALL the lines? The warning is common when Caller ID is enabled on a trunk and no CID is sent, have you verified it is there with a butt set between the first and second ring indication? Also, there are timers that can be adjusted for the CID, although I have never had to.

Title: Re: Caller ID works intermittently
Post by: DND ON on December 19, 2013, 08:26:27 AM

If the error messages only refer to that one loop start port [10.1.1], that’s the one causing your “intermittent” problem.

Title: Re: Caller ID works intermittently
Post by: canadaed on December 19, 2013, 09:19:48 AM

I went back into the logs and it looks like 10 1 1 is only reporting this problem. I will go back to the site and do some further testing. Thanks

Title: Re: Caller ID works intermittently
Post by: 619Tech on December 20, 2013, 03:17:33 PM

Caller ID is not enabled by default. There may have been a trunk added or a missed setting during installation. Check all your loop start trunks:
System/Devices and Feature Codes/Trunks/94101(example)/Service Type: Caller ID (set to None on default).

Title: Re: Caller ID works intermittently
Post by: canadaed on December 20, 2013, 04:09:20 PM

That was one of the first things I did check, and it is set to Bellcore.

Title: Re: Caller ID works intermittently
Post by: Tech Electronics on December 21, 2013, 04:36:59 PM

Canadaed,

Were you able to determine whether you were getting the CID splash tones when monitoring the line with your butt-set? If you are not then you need to turn the issue over to the carrier to get that resolved. If you are getting them you may just need to reset the hardware for that trunk or swap them to a known working trunk and see where the problem moves to.

Thanks,

TE

Title: Re: Caller ID works intermittently
Post by: canadaed on December 24, 2013, 02:19:29 PM

I have not made it back to the site yet. I was thinking the same as you, and would interchange trunks to see if the problem follows. In the meantime, I have asked the customer to check with the Telco to make sure they are subscribed to name and number display for that trunk. Thanks for the suggestions.