Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: ralph on November 18, 2013, 09:46:13 AM

Title: How to know if Mitel 3300 has resilient hard drives
Post by: ralph on November 18, 2013, 09:46:13 AM

Does anyone know if there is a command that will show you if a system has redundant hard drive?

Ralph

Title: Re: How to know if Mitel 3300 has resilient hard drives
Post by: marcolive on November 18, 2013, 09:54:10 AM

SHOW STATUS REDUNDANT

You will have this kind of output :

Redundant Status:

   Power                Seated    Input  Output Fan     Temp.
   Supply    Installed  Fault     Fault  Fault  Fault   Fault
   ------    ---------  --------  -----  ------ -----  ------
     1          Yes          No     No     No     No     No   
     2          No         ---     ---     ---     ---     ---   

   Fan       Running
   ------    -------
     1          Yes
     2          Yes

   Temperature
   Sensor         Temperature    Alarmed
   ------         -----------    -------
    1                  26          No   
    2                  25          No   

RAID Controller
RAID Temperature Alarm Inactive

   RAID controller temperature 24. C 
   RAID controller rebuild is idle.

   Hard               Hard    Soft
   Disk   Installed   Fault   Fault
   ----   ----------- -----   -----
     1        Yes      No     No   
     2        Yes      No     No   

Title: Re: How to know if Mitel 3300 has resilient hard drives
Post by: x-man on November 18, 2013, 09:59:07 AM

or shpw status Raid.

Title: Re: How to know if Mitel 3300 has resilient hard drives
Post by: ralph on November 18, 2013, 10:10:42 AM

Thank you.
These are some commands that I almost never use but I'll have to sometime today to verify a server I'm upgrading.

Ralph