Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: stuart3380 on March 07, 2013, 02:17:40 AM

Title: Set 5224 in to static ip mode
Post by: stuart3380 on March 07, 2013, 02:17:40 AM

Hi

Could somebody explain how to set the 5224 in to static ip mode. I am trying to boot from a remote network, and the teleworker function is not working. I am connected via VPN and can ping and access the 3300 from my remote location.

I can navigate to the static network parameters but a bit confused which IP address etc
To enter. Any help would be much appreciated

Many thanks

Title: Re: Set 5224 in to static ip mode
Post by: johnp on March 07, 2013, 06:06:06 AM

If asked ipv4. If you don't use 3 digits, use the # for a dot. Settings needed will be: ip address, subnet mask, gateway, icp address and tftp (these last two would be controller)

Title: Re: Set 5224 in to static ip mode
Post by: stuart3380 on March 07, 2013, 07:32:07 AM

Hi

i am now getting the IP showing on the phone, but i am getting RTOS DHCP timeout??

Guessing it is not seeing the servers?

Title: Re: Set 5224 in to static ip mode
Post by: LoopyLou on March 07, 2013, 09:21:18 AM

What IP values are you filling out? You need to do the phone address ( with subnet )  then the gateway, RTC and TFTP.  I would not use teleworker mode since you have no teleworker.

Boot the phone holding the up volume key release and then select configure the phone, then network parameters and then skip all the view options until you see modify phone settings. Say yes and then fill in the above. IF  you need VLAN info you may  need to add that. You can also put in L2 priority but its not necessarily needed.