Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: abmitel on December 06, 2023, 11:22:34 AM

Title: MiVB upgrade from Ax ver 6.0 GA to ver 10.0
Post by: abmitel on December 06, 2023, 11:22:34 AM

Hi
we have received new AX controller card and new Flash 16 gb with preloaded ver 9.4 .
we removed the existing controller and flash and replaced with new set
we get error " cannot boot " on console login

Please sugget

Warm Regards
Abu Shaikh
+919004687522

Title: Re: MiVB upgrade from Ax ver 6.0 GA to ver 10.0
Post by: lundah on December 06, 2023, 03:10:21 PM

What version 6 release? You need to be at 6.0UR3 to use the Migration utility to do the VXWorks to uBoot migration. Go to edocs.mitel.com and find the Migration Guidelines doc for MiVB release 9.4, make sure you understand that before continuing. You'll need to run an audit on the 6.0 system to ensure that migration is possible without making some changes/corrections to system programming, then run the migration tool to actually upgrade the AX firmware to support the o/s switch.

Title: Re: MiVB upgrade from Ax ver 6.0 GA to ver 10.0
Post by: abmitel on December 12, 2023, 04:53:46 AM

Hi
we upgraded system from v 6.0 to ver 8.0 then to ver 9.4

finally we upgraded ver 9.4 to ver 10 .

the upgrade is successful .

we have 2 system in cluster . in one of the cluster system we are facing issue the 24 ONSP card not detecting .

earlier it detected when we upgraded the system , but now it is not detecting .

Regards