Mitel Forums - The Unofficial Source
Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: Curtin_BPW on April 30, 2021, 03:19:12 PM
-
Does anyone have 3.0 or 4.0 software they can PM over? Mitel has taken down so much legacy documentation and software.
-
Why wouldn't you just use the latest 5.0 that is available on the site?
The software key works from 4.0 for sure, probably 3.0 as well.
-
I am nervous to jump so many major release at once
-
I am nervous to jump so many major release at once
Fair, but check the technicians handbook or the latest release notes, I think you can from 2.X all the way to 5, but not from 1.X.
-
Yeah I found documentation that local upgrade via CF and is supported (FTP upgrade is not supported for 2.0 to 5.0). I have a SX-200 MX Controller that I pulled off the shelf in my office that would not boot that was found in a recycling pile, diagnosed it, pulled a DSP card out of the MMC slot, and got it to boot! I want clone the drive and then practice a local software upgrade on it via CF before heading to the field to do this.
I then want to though the original drive with older software/licensing back in and use it in my lab in the office for testing things. Does anyone know of a backdoor way to reset a SX-200 password without going through support. I have read this is possible on the 3300. Not worth spending the money to get SX-200 certified at this point with it just getting announced to be EOL (certified in 3300 and 470) and want to use it as a lab system.
-
To my knowledge, the SX200 cannot have the password reset without support... I haven't found a backdoor or anything to get in. The best you can do is a new CF from Mitel and start clean, it might even be cheaper, not sure as I haven't had a password reset done a 200 for many years.