Mitel Forums - The Unofficial Source

Mitel Forums => MiVoice Office 250/Mitel 5000 => Topic started by: RLyon on October 14, 2019, 05:15:07 PM

Title: horn paging
Post by: RLyon on October 14, 2019, 05:15:07 PM

I have a paging horn going to an amp and then to the mitel loop start 4. I cant get it to work. Page zones (9600)> trunks>94001 (92001 analog). What am I missing?

Title: Re: horn paging
Post by: Tech Electronics on October 14, 2019, 09:29:49 PM

RLyon,

Is the device you hooked up to providing battery to the loop start port?

If you hook up your buttset do you hear any audio when dialing 9600 or the trunk directly?

If you dial the trunk directly what does it do?

Thanks,

TE


Sent from my iPhone using Tapatalk

Title: Re: horn paging
Post by: RLyon on October 15, 2019, 10:42:47 AM

I call it from an inside office phone and it doesnt ring (makes no sound) and it hangs up immediately

Title: Re: horn paging
Post by: Tech Electronics on October 15, 2019, 10:45:22 AM

RLyon,

What is the name of the device you hooked up to the LS port? I will look it up and see how it is supposed to be configured.

Thanks,

TE

Title: Re: horn paging
Post by: RLyon on October 15, 2019, 10:54:40 AM

well for 1, I just had the butt set hooked to the Loop start and it didn't ring and immediately hung up, but it's a crown amp (which I'm sure is correct) Channel 1 Black (Tip) is positive and Yellow (Ring) is negative

Title: Re: horn paging
Post by: Tech Electronics on October 15, 2019, 10:59:54 AM

RLyon,

Do you mean to tell me that you hooked a Loop Start Port directly up to an Amplifier without a Loop Start Interface? You will most likely need an interface like a Viking PI-1A or something similar to get that to work.

Why don't you just come out of the Paging Interface of the system?

Thanks,

TE

Title: Re: horn paging
Post by: RLyon on October 15, 2019, 01:29:06 PM

thanks, it works better