Mitel Forums - The Unofficial Source
Mitel Forums => SIP On Mitel => Topic started by: Migue on October 09, 2019, 05:48:38 PM
-
Hello comunity :D
I have a Mitel 5312 IP device, which I configure in SIP mode, and in order to complete the configuration I have to put the address of the server that registers with its respective port, however my problem is that having the HTTP port enabled I can not access the web configuration is not a problem of the cable path since I change it repeatedly, I assigned IP address both static and dynamic, however I can not access the web configuration, check the connectivity between the computer and my PC giving positive results, but I can not access.
I will be very grateful for your collaboration in providing a solution or alternatives.
Best regards.
-
Are you logging in as admin with the correct password?
-
Of course, in fact I have not made any modification, the equipment is as it is after restoring it in its factory state, I recently investigated this matter and I understood that this problem is due to the fact that its firmware version is (06.05.00.15 ), which Mitel rejected this option of web configuration, I suppose that my only alternative would be to implement a firmware that is adequate to access that web interface ... but the other problem is where I get that firmware.
The right thing to say is a matter of firmware, or do you think there may be another alternative?
Thank you so much :)
-
http://mitelforums.com/forum/index.php?topic=11111.0 (http://mitelforums.com/forum/index.php?topic=11111.0) the files I am sharing should have what you need
-
Yes, this problem is very common in SIP phones with older models, I already found the solution, thank you very much for your help. ;D