Mitel Forums - The Unofficial Source
Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: rkowals on September 24, 2019, 10:35:03 AM
-
We have a SX-200_ICP, we have different Page numbers depending on location of phone in a building, question is, do I need this Myadministrator software to program the phones for each page group? if so, where can I find the software?
-
You don't need it. You can program the system with a Putty console raw 2000
-
How would this be any different than accessing it via the web interface?
-
It is a terminal type of connection and is faster than the web to do programming. It looks more like the SX200 light or ML/EL programming
-
What SX200 Manual should I look up to program the lines?
-
The documents from Mitel were FolioViews nfo files. I don't know if there are any available on-line. I would try www.wedophones.com and see what is there. If only Sx200, the Lightware 16 version will have most basic info
-
The documents from Mitel were FolioViews nfo files. I don't know if there are any available on-line. I would try www.wedophones.com and see what is there. If only Sx200, the Lightware 16 version will have most basic info
On the Mitel website there is the SX200 ICP 5.0 SP2 docs in PDF format... It's the complete NFO converted to PDF.
It is in the LMS in the Resources section. ;)
-
I don't know if the OP has a Mitel account. I still use the nfo for this and 2000 stuff when needed.
-
I don't know if the OP has a Mitel account. I still use the nfo for this and 2000 stuff when needed.
Thankfully I have not had to touch an SX-2000 since 2010 when I moved out away from Rochester, MN, and I doubt I ever will touch one again.