Mitel Forums - The Unofficial Source

Mitel Forums => MiVoice Office 250/Mitel 5000 => Topic started by: CLI_ninja on August 29, 2019, 12:24:31 PM

Title: View Outpulsed Digits Sent to CO - MiVO 250
Post by: CLI_ninja on August 29, 2019, 12:24:31 PM

Hello, I'm playing around with ARS and would like to see what digits are getting sent to the CO....is there anywhere to view via the SAD tool?  Or, any other method?

Title: Re: View Outpulsed Digits Sent to CO - MiVO 250
Post by: Tech Electronics on August 29, 2019, 12:37:41 PM

CLI_ninja,

That all depends on what type of trunking you have associated with that CO Trunk Group.

If it is an ISDN type trunk then you will need to get into Command Line of the controller and run the ISDN Diagnostics and then you see what it is sending out for data.

If it is SIP then you just need to turn on the SIP Logging and you can see what it is sending out within the SA&D tool.

If it is a Loop Start Trunk then you will need to get a digit grabber and hook it up.

Thanks,

TE

Title: Re: View Outpulsed Digits Sent to CO - MiVO 250
Post by: CLI_ninja on August 29, 2019, 01:11:29 PM

Tech Electronic....thank you.  This is PRI.  D-Channel Diag revealed one of my digits was getting truncated.