Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: Northeaster on November 10, 2010, 12:26:19 PM

Title: Replacement 3300CXI not booting up with old i-button
Post by: Northeaster on November 10, 2010, 12:26:19 PM

Hi Folks,

I got a replacement 3300CXi controller (old one damaged in shipping) and added the old i-button, t1 card, 512m ram (replacement only came with 256m), APC card and it's hard drive.

The i-button brackets on the replacement chassis, likely refurbished, seemed loose, and did not hold the button tight.  I bent them a bit, so they hold it tighter.

Anyway, I get the following error message from the maintenance port as soon as I apply power: (it doesn't go any further.)  Any ideas??


ERROR - Failed to receive acknowledge during send command:
        I2C Client:   0x50
        I2C Register: 0x05


ERROR - Failed Device Address Write in Read command


M

ERROR - Failed to receive acknowledge during send command:
        I2C Client:   0x50
        I2C Register: 0x05


ERROR - Failed Device Address Write in Read command


M

ERROR - Failed to receive acknowledge during send command:
        I2C Client:   0x50
        I2C Register: 0x05


ERROR - Failed Device Address Write in Read command


M

Title: Re: Replacement 3300CXI not booting up with old i-button
Post by: Northeaster on November 10, 2010, 01:50:15 PM

My fault. RAM was not in tight.

Title: Re: Replacement 3300CXI not booting up with old i-button
Post by: ralph on November 10, 2010, 03:11:14 PM

Gotta love the easier fixes.

Ralph
www.univerversity-music-on-hold.com (http://www.univerversity-music-on-hold.com)