Mitel Forums - The Unofficial Source
Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: nMitel on October 19, 2018, 04:20:16 PM
-
Hi.
my Sx200 ICP is not loading I keep getting
machine check
Exception next instruction address: 0x00073ccc
Machine Status Register: 0x00046030
Condition Register: 0x80000000
Task: 0xd390000 "tAppStartup"
xfile: cannot write /db/xrtc file too big
not sure what causes that. what could be done to solve this.
-
It likely is going to be either the hard drive or the dsp module
-
My money is on a hard drive failure... How far into the boot sequence does it get if you monitor the bootup through the serial port with power off?
-
surprisingly the system came back up after an extended period of time of loops through these errors, it happened shortly after I got the DSP module delivered to the site and before replacing in it or do anything on the controller!
-
First thing I would be doing is a backup... then a printout of all the forms. :)
-
acejavelin already done. this system is on its way for retirement :)
-
one more thing here. this system does not have a hard drive but there is an 8GB flash card, does it act like the hard drive in this case?
-
one more thing here. this system does not have a hard drive but there is an 8GB flash card, does it act like the hard drive in this case?
This is an ICP system? Is it a CX/CXi, MX, or AX?
The CX/CXi and MX have a traditional HDD with an IDE interface (40-pin), typically 40-160GB.
The AX uses CompactFlash card(s) on the processor card, they are 8GB if I recall correctly, and yes they are essentially a hard drive to the system.
-
Room status not changing when housekeeping puts in code on room phone. Help Help!!!
Sent from my LG-M322 using Tapatalk
-
Room status not changing when housekeeping puts in code on room phone. Help Help!!!
Sent from my LG-M322 using Tapatalk
Room status is not changing in the PBX or in the PMS?