Mitel Forums - The Unofficial Source

Mitel Forums => MiVoice Office 250/Mitel 5000 => Topic started by: NTEDave on April 23, 2018, 07:51:39 AM

Title: Reboot due to "Code Change"
Post by: NTEDave on April 23, 2018, 07:51:39 AM

Anyone had reboots caused by a "Code Change" recently, I thought they were a thing of the past!

Got a 6.2 SP2 PR5 doing it monthly ish, sending it over to Mitel TS at the minute but was curious to see if anyone else has had it recently?

Title: Re: Reboot due to "Code Change"
Post by: acejavelin on April 23, 2018, 09:19:52 AM

Haven't seen that one in a while... years ago there were some software bugs that caused that, but other than that the only time I have seen this is corruption/failure of the CF card.

Title: Re: Reboot due to "Code Change"
Post by: DND ON on April 23, 2018, 10:42:51 AM

I've seen "Code Change" reboots that were actually caused by power issues.

Title: Re: Reboot due to "Code Change"
Post by: NTEDave on April 24, 2018, 09:05:08 AM

The system has had a new Compact Flash when I upgraded to 6.2 SP2 PR5, I did go out to site once as the system was completely down and all I needed to do was hit the central button to bring it back up.

Power issues could be the culprit as there is some heavy building work going on near by.

Title: Re: Reboot due to "Code Change"
Post by: Tech Electronics on April 24, 2018, 10:16:39 AM

NTEDave,

Almost every time I have seen that error it was due to power issues.

1. Brown-outs
2. Square-Wave UPS

Thanks,

TE

Title: Re: Reboot due to "Code Change"
Post by: NTEDave on April 25, 2018, 04:25:01 AM

Thanks everyone

The customer now has a quote for a UPS to power the system.

In my defense the system was on a UPS until they built a new comms room and moved all of the servers and UPS's to it leaving the phone system in the old location.  :(