Mitel Forums - The Unofficial Source

Mitel Forums => Mitel MiVoice Business/MCD/3300 => Topic started by: Frontline on September 28, 2017, 03:49:55 PM

Title: Message wait key calls HCI reroute group
Post by: Frontline on September 28, 2017, 03:49:55 PM

I have a vMCD version 8.0 SP2 14.0.2.26 with a NuPoint version 19.0.0.25.

Integration is working. I can leave a user a message and it lights the light. However, when I go off hook and press the flashing envelope key, the call rings to the HCI reroute hunt group. I think i've seen this before and was a simple configuration error, but for the life of me i can't remember what the problem was.

If I reroute the HCI hunt group always to voice mail, pressing the key will then take the user to their mailbox, but I don't think that is the correct resolution!

 

Title: Re: Message wait key calls HCI reroute group
Post by: SARTECH87 on September 28, 2017, 06:35:13 PM

i think you have to configure the voice coverage\voicemail tab with your voicemail hunt group i.e. 3000 if 3000 is your hunt group for voicemail

Title: Re: Message wait key calls HCI reroute group
Post by: johnp on September 28, 2017, 08:35:10 PM

That is as it should. May need to reroute it

Title: Re: Message wait key calls HCI reroute group
Post by: Frontline on September 29, 2017, 08:33:13 AM

I did have the voice mail hunt group programmed in the call coverage form

Anything else I nee to look at or is rerouting the HCI hunt group to voice mail the right way to set this up?

Thank you again for the advice

Title: Re: Message wait key calls HCI reroute group
Post by: SARTECH87 on September 29, 2017, 08:06:54 PM

is your HCI reroute MWI in Nupoints configured properly? we use the loc code + 40... there is not too many thing to be configured.
but there is also another thing that you may look at that is not mentioned, check the features for that extension. That message waiting light may also be a Call back message light. Perhaps that feature is active and not being looked at

Title: Re: Message wait key calls HCI reroute group
Post by: sarond on September 29, 2017, 08:19:45 PM

What you have done is correct.
The HCI Group leaves the MWI but when you call it back it needs to go to the VM Hunt Group.

Title: Re: Message wait key calls HCI reroute group
Post by: Karptemo on October 02, 2017, 02:43:43 AM

Did you end up re-routing it and having it work?

Title: Re: Message wait key calls HCI reroute group
Post by: Frontline on October 02, 2017, 09:35:05 AM

Thank you all for the input

Karptemo: I did end up just rerouting the HCI reroute group to the pilot number of the Voice Mail hunt group and this does work correctly