Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnp

Pages: 1 [2] 3 4 ... 141
16
Toll plan and cor would be how I might do this

17
Not sure what setting was wrong, let us know

18
I would start by disabling T.38 on the ATA

19
Just had to do a raid hard drive replacement, at a near latest version :-)

20
If it is uboot, looks like this is partition1 or partition 2

21
In theory, you could license this and restore, would have to clear hardware id on AMC. Can then restore original value

22
Mitel MiVoice Business/MCD/3300 / Re: MultiCall Recording Software
« on: September 08, 2023, 05:53:19 PM »
Would need to know controller and how many involved

23
Mitel MiVoice Business/MCD/3300 / Re: ICP3300 MX Controller
« on: September 07, 2023, 05:31:01 PM »
This should help

24
Introduction and Announcements / Re: Hello from Spain!
« on: September 07, 2023, 05:12:38 PM »
Welcome

25
It going to be some kind of raid driver missing on the MSL, I would try the VMware

26
It would be under the function key, might be function system? But looking at the display options should make sense. It may be required in cos, been a while since I've had to do this

27
SIP On Mitel / Re: PRI to SIP
« on: August 18, 2023, 04:41:55 PM »
You can always check the adtran forum, think this setup is widely sharded and is not too diffult to get working either sip to pri or pri to sip in the Mitel environment.

I've done both and only needed tp turn prack off on the Mitel when I had a call issue.

28
I also find Grandstreams to work easier that either audiocodes or the mediatrix/mitel units. The 813 works great for adding an fxo port and they have a great price point.

29
Mitel MiVoice Business/MCD/3300 / Re: Class of Restriction
« on: August 14, 2023, 05:25:19 PM »
Might think they got some intercept setting to vm, cor does not do anything to caller id, Might look at zone assignment.

30
I use Phoner lite, as a test phone. SMB could or should have the MBG

Pages: 1 [2] 3 4 ... 141