616
Mitel MiVoice Business/MCD/3300 / Re: Caller ID on second line
« on: May 20, 2008, 10:56:07 AM »
You can press superkey and the line that is ringing and it will show you the caller id.
News:
Welcome to Mitel Forums. The Mitel resource - by techies, for techies...
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
617
Mitel MiVoice Business/MCD/3300 / Re: New Rollout
« on: February 19, 2008, 04:13:20 PM »
Nope if you are listening to dial tone and press the message key when it is flashing it will call voice mail or whoever left you a callback message.
618
Mitel MiVoice Business/MCD/3300 / Re: How to change IP address on ICP-3300?
« on: February 05, 2008, 07:55:10 PM »
If the controller does not have the E2T statically programmed its fairly easy to change the 3300 IP
previous to release 7 plug into the maintenance port on the front of the controller and type BootChange it is case sensitive and fill in the IP addresses subnet and gateway.
If it is post release 7 go into the IP assignment form make your changes and reset the controller.
Be sure to change the DHCP options in whatever you are using to hand out addresses to the phones.
The YA Server is a bit more complicated IIRC if you change the IP you either have to open a databese file in access and change the IP of the server there or remove the application and delete the directory and reinstall the software. Make sure you have the application record ID so you can resync the server with the Mitel AMC.
That being said a call to your dealer couldnt hurt.
previous to release 7 plug into the maintenance port on the front of the controller and type BootChange it is case sensitive and fill in the IP addresses subnet and gateway.
If it is post release 7 go into the IP assignment form make your changes and reset the controller.
Be sure to change the DHCP options in whatever you are using to hand out addresses to the phones.
The YA Server is a bit more complicated IIRC if you change the IP you either have to open a databese file in access and change the IP of the server there or remove the application and delete the directory and reinstall the software. Make sure you have the application record ID so you can resync the server with the Mitel AMC.
That being said a call to your dealer couldnt hurt.
619
Mitel MiVoice Business/MCD/3300 / Re: New Rollout
« on: February 05, 2008, 07:48:14 PM »
If the MWI light is flashing you can pick up the handset and press the message button and it should call voice mail.
You might be able to reprogam the button with the HTML toolkit if the phones are 5330 and 5340s.
You might be able to reprogam the button with the HTML toolkit if the phones are 5330 and 5340s.