Mitel Forums - The Unofficial Source
Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: SXTech on September 07, 2017, 12:24:06 PM
-
Just got an SX-200 AX and it does not get past auto-boot.
The parameters look correct and I tried to follow the THB, but no luck.
I installed the 4gig CF in Slot 1 and there in nothing in slot 2
What am I missing?
-
Slot 1 is for upgrades, and slot 2 is the system CF, move the compact flash to slot 2 (under MMC1, the lower slot on the card) and it should boot up fine.
-
Thank you Ace.
I moved the CF to slot 2 and now it says can't load boot file.
-
Thank you Ace.
I moved the CF to slot 2 and now it says can't load boot file.
It should definitely be in Slot 2, sounds like a bad/corrupt CF card.
-
I will try to reburn the software on the CF and let you know what happens.
Appreciate your input.
-
It's all good, got it going.
Thanks again.