Mitel Forums - The Unofficial Source
Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: mutombogeorge on August 18, 2011, 05:38:41 AM
-
Hi,
I have a SX2000 light. I whant to add a new card in aperiferal cabinet,; but don't remember how to make a configuratin. I can see the card installed on my sreem, when I try to configure, it says" There is no more room for new records".
In the programmed card colomn, I just wright "COV Line " then press "4-Commit" then "1 confirm".
-
it says" There is no more room for new records".
This means that you've reached the maximum capacity that your software level can support.
When you're at the main CDE menu, hit <esc>6 (read) then enter "Dim and fe dis" it should show you how many of what devices you have.
Ralph
-
Hi Ralph,
In the same menu, after getting the message "There is no more room for new records" On the bottom of the screem,by pressing the key #2, you will have to make the range programing which I don't know what it is for. Then it will ask for the number of line.
That means I just forgot the complet procedure to configure the COV card in new slot. I did it only one time to make two COV cards.
-
I'm not sure I understand.
Were you able to add the card?
Ralph
-
I have one peripheral cabinet which is running with 3 COV cards, now I have to add one or if possibility two, tree more cards. The system can see the card I'm adding in the cabinet, my problem occur when I try to program the card in the same slot I installed it.
mutombogeorge.
-
The problem is you will have to upgrade your options in order to add more cards.
You'll need to see your dealer so they can sell you an MFRD table upgrade.
Ralph