Author Topic: Restarting PRI line  (Read 3218 times)

Offline synthesis

  • Jr. Member
  • **
  • Posts: 74
  • Country: za
  • Karma: +1/-0
    • View Profile
Restarting PRI line
« on: September 21, 2016, 11:32:18 AM »
Hello. I have been trying to restart the PRI line with PLID 2 1 3. Tried using the maintenance command LOAD 2 1 3, but the following error was returned: Card at location  2  1  3 not supported by LOAD command. Is there another way to restart the PRI line, without restarting the whole Mitel 3300 system?


Online ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Restarting PRI line
« Reply #1 on: September 21, 2016, 01:44:04 PM »
That's not a card you can reload.
Unless some else know something different, the only way I know how to reboot that card is to reboot the controller.
I can't think of a case, though, where that has made a difference.

Ralph

Offline lundah

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1216
  • Country: us
  • Karma: +66/-0
  • Senior Chief Grunt
    • View Profile
Re: Restarting PRI line
« Reply #2 on: September 21, 2016, 04:13:46 PM »
You used to be able to load a T1 card, but they took away the ability to do that around MCD 5.0. The only workaround I've found is to change the Digital Link Descriptor, which will also bounce the card.

Online ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Restarting PRI line
« Reply #3 on: September 21, 2016, 04:50:33 PM »
Quote
The only workaround I've found is to change the Digital Link Descriptor, which will also bounce the card.

Good one lundah.  That hadn't ever occurred to me even though I should have know it.

Ralph


 

Sitemap 1 2 3 4 5 6 7 8 9 10