How Put Restriction On Mitel

[misbah1981]

Dear All,

I have Mitel 3300 with access code 9 for taking PRI almost 200 Extension
i add new 25 IP extension but wants to take acess code 6 and taking CO Line
9 access code restricted for these new 25 extension
can any body tell me how its happen
Thank in Advance

Regards,
Misbah

[acejavelin]

If you have no restrictions at all at the moment (COR 1 everywhere), then the restrictions will have to be built in ARS before you can apply them... this should not be attempted by someone untrained or at least very familiar with ARS programming, if done incorrectly it could cause all outbound calls to fail or be mis-routed, and if you are in a networked environment this could mess with your clustering as well. I would recommend contacting your vendor at least for the initial setup of toll restriction.

[misbah1981]

Many Thanks Yes already have restriction
any idea how can do

[acejavelin]

Look at a station that is already restricted and note it's COR (Class of Restriction), then go to the set you wish to restrict and change it to the same COR. Simple as that.

[ralph]

Take a look at this link to see if it helps you.
www.mitelforums.com/articles/mitel_ars_programming.php

Ralph