Author Topic: Rel 7 DID's  (Read 1234 times)

Offline mah437

  • Contributer
  • *
  • Posts: 12
  • Country: us
  • Karma: +0/-0
    • View Profile
Rel 7 DID's
« on: February 10, 2015, 10:47:58 AM »
I have this all figured out in 6 with NUpoint using the speed call form.  But now I have rel 7 and I am using the built in MLAA. I can not get DID to route to an internal extension.  Right now I have it set to absorg 0 and the 'Dial in trunk Answer point' is 7300 (my voicemail group)

I was assuming that to use the 'DID service form'  that I need to turn on 'Direct inward dialing services', in trunk attributes,absorb 3, and then remove the 7300.

Then in the 'DID service form' I have entered in the correct DID information and the destination extensions. I can not get it to answer after I do this.

is there a log or maintenance command that I can check the incoming digits from the provider,  I know there is but I can not find my notes.


Offline mszodiac

  • Sr. Member
  • ****
  • Posts: 232
  • Country: ca
  • Karma: +7/-0
    • View Profile
Re: Rel 7 DID's
« Reply #1 on: February 11, 2015, 08:44:33 AM »
You can run ccs trace enable continuous on the MCD command line to see your incoming digits from the Telco.

Make sure you disable ccs trace after as it can fill up the buffer.


 

Sitemap 1 2 3 4 5 6 7 8 9 10