Faulty Power supply

[tone-the-phone]

I have an SX2000 DSU cabinet with a faulty power supply, it kept cycling off and on which when checked remotely appeared to be a card fault but the only way I could diagnose the problem was to go to site, the clue being that the fan was stopped and the whole cabinet was power cycling.
This raises the question is there a maintenance command that can be used remotely to determine the condition of the power modules in the cabinets?

[ralph]

I've never seen one.
Perhaps the STAT command may do it.
The only time I've ever had a 2k PS go bad it was always the ring voltage. 
I can't remember ever doing a STAT on a faulty one.

Ralph

[tone-the-phone]

Ralph
Thanks for the reply, I tried some stat commands but nothing came up.  Do you know if the power supply detects cabinet temperature and turns the fan on when needed or should it run continuously?

[ralph]

It runs continuously.

Ralph