Author Topic: DID  (Read 2775 times)

Offline mevans1974

  • Jr. Member
  • **
  • Posts: 45
  • Country: bs
  • Karma: +0/-0
    • View Profile
DID
« on: March 19, 2014, 09:48:19 PM »
Hi,
I have a issue we have a SX200 ICP we just installed a T1 DID However, what have a issue our DID dont match our exten. Is there a way I can map my DID to a non DID extn.
This is not a PRI.


Offline johnp

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2209
  • Country: us
  • Karma: +67/-0
    • View Profile
Re: DID
« Reply #1 on: March 20, 2014, 04:45:06 PM »
Programming
In Form 02, Feature Access Codes, program Feature Access Code 67 (Digit Translation Table Access). The code is restricted to two digits or less.

In Form 15, Dial-In Trunks, select the dial-in trunk and program the following fields:
N - match the expected number of incoming digits
M - absorb leading digits (maximum 8 digits)
X - Feature Access Code 67 (use the code programmed in Form 02)

Note:   If field X on Form 15 contains a number rather than Feature Access Code 67, the Digit Translation Table is not consulted. Instead, the number (up to two digits) is inserted ahead of the digit string before the call is routed to its destination.

In Form 55, Digit Translation Table, program the answer points (extensions or Abbreviated Dial numbers) where calls received by dial-in trunks will route based on Day Service, Night1 Service, and Night2 Service.

In Form 19, Call Rerouting Table, program the "DID Illegal # Intercept for this Tenant" intercept.


 

Sitemap 1 2 3 4 5 6 7 8 9 10