Mitel 5000 HX v6 BRI connection in Germany

[bez1982]

Hi All,
I am installing a Mitel 5000 HX in Germany and cannot get the ISDN BRi to work, I get engaged on inbound and disconnection on outbound.

The Site is using an Access 100 Modem to translate the BRI locally to Netcolognes SIP network which is the standard in Germany.  it is DSS1 ETSI Standard.

Fixed 0 is set on TEI setting on the port, and due to the fact they do not "En-Bloc dial in Germany Overlap send and receive is set to YES.  Anyone have anything similar or a solution to this? I believe it's a digit presentation issue between the Mitel and the netwrok in the Call routing table/Trunk groups but can't seem to tell.

thanks

Andy

[Tech Electronics]

Bez1982,

You are going to need to look at your setup messages and work with the carrier on what you see and what they receive.

Thanks,

TE

[bez1982]

Thanks Steven,
How would you suggest I get the readout via diagnostics on an SSH connection, is there advanced logging I can view from there as I'm not getting much from the system monitoring print.
Regards
Andy

[Tech Electronics]

Bez1982,

You will need to get into the digital card circuit and turn on Layer 2 D channel diagnostics, just don't forget to turn it off.

Thanks,

TE

[bez1982]

Many thanks,  Not really sure what to look for but the read out looks like this

*** D-RX [01]:  16:26:53   00 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1          RR

*** D-RX [02]:  16:26:53   00 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1          RR

--- D-TX [01]:  16:26:53   02 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1     RR

*** D-RX [02]:  16:27:03   02 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1          RR

--- D-TX [02]:  16:27:03   02 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1     RR

--- D-TX [01]:  16:27:03   00 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1     RR

*** D-RX [01]:  16:27:03   00 01 01 01
            SAPI=00   TEI=00           NR=00   PF=1          RR

[Tech Electronics]

Bez1982,

Unfortunately this is where you would need to work with the carrier to know what they are looking for from you and what they are receiving. At least now you can tell them what you see going out.

Thanks,

TE