« previous next »
Pages: [1]   Go Down

Author Topic: Deleting LS Trunk  (Read 1519 times)

Offline pakman

  • Sr. Member
  • ****
  • Posts: 483
  • Karma: +1/-0
    • View Profile
Deleting LS Trunk
« on: October 23, 2013, 02:25:21 PM »
I'm trying to delete a analog trunk and I get "device is not man-busied" this line is not in use so I'm not sure why I get this or how to resolve it. When I access the trunk using the individual trunk access code it throws a busy signal at me. I have tried to delete it after I unplugged the cable from the PBX and that didn't work.
Logged

Offline jrg0852

  • Sr. Member
  • ****
  • Posts: 309
  • Country: us
  • Karma: +3/-0
  • Look out for the next tech. because it may be you!
    • View Profile
Re: Deleting LS Trunk
« Reply #1 on: October 23, 2013, 02:28:26 PM »
You will need the PLID of the line you are trying to delete. You will then enter the command: BUSY X-X-X-X, where X-X-X-X is the PLID for the line. Once busy you can delete it.
Logged

Offline pakman

  • Sr. Member
  • ****
  • Posts: 483
  • Karma: +1/-0
    • View Profile
Re: Deleting LS Trunk
« Reply #2 on: October 23, 2013, 02:33:40 PM »
Thanks I just figured this out and was going to remove my post.
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10