« previous next »
Pages: [1]   Go Down

Author Topic: MXE 3 hard drive change.  (Read 2028 times)

Offline ianbt001

  • Jr. Member
  • **
  • Posts: 62
  • Karma: +0/-0
    • View Profile
MXE 3 hard drive change.
« on: October 01, 2013, 07:28:58 AM »
Gents. after a spot of advice, had a hdd fail on an MXE 3 and needed to change HDD 2.

When I put in new drive from Mitel (same part code) it can see it but flashes SOS.

Am I right in thinking this is caused by drive size mis match or am I missing something?? ??? ???
Logged

Offline Mattmayn

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1069
  • Country: vi
  • Karma: +14/-0
    • View Profile
Re: MXE 3 hard drive change.
« Reply #1 on: October 01, 2013, 07:34:31 AM »
Do you have the LED indication chart for the RAID system? It flashes different rates for different reasons. I think fast flashing means that the RAID is rebuilding, this takes 4ish hours I think.
Logged

Offline ianbt001

  • Jr. Member
  • **
  • Posts: 62
  • Karma: +0/-0
    • View Profile
Re: MXE 3 hard drive change.
« Reply #2 on: October 01, 2013, 08:01:28 AM »
Leds flash as per note from THB as shown below but need to know what causes it.

Mismatch BLUE
BLUE flashing
SOS signal
(Three quick flashes
followed by three slow
flashes)
HD 2 was swapped but
does not match
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10