Reverting from MCD 6.0 to MCD 5.2 SP2

[kwahodi]

Hi all,

I've got a wierd one....are you able to rivert from MCD 6.0 to 5.2 sp2? An online upgrade was done using SI tool to MCD 6.0 however, the AMC side of things had not been sorted out and there was no software assurance. Hence the controller now is in licence violation which is being presented on all handsets. If SA is not sorted out, are you able to revert back to MCD 5.0? There is a pre-upgrade backup available. Also, will the SWAP command be handy in such a situation?

Cheers!

[ralph]

I think if you did the upgrade with the SI tool then you should be able to issue the swap command and you should be back up with in a few minutes on 5.2 without an issue.

Ralph

[LoopyLou]

Think the Swap command is the way to go. If you can't do that if the Software assurance is not fixed you may have issues syncing if you just re-install the MCD 5.2.

[kwahodi]

Hi Guys,

Did not have to revert - we managed to sort out AMC licensing. Thanks for your suggestions and its good to know that it can be done.

Cheers!

[LoopyLou]

Simpliest solution is usually the best.