Mitel Forums > Mitel MiVoice Business/MCD/3300

3300icp vlan

(1/5) > >>

NewVoIP:
hello,

When 5340 boots and indicates vlan none pri none, why is this happening. When we have set on our HP switches vlan 30 (VoIp) and priorty 7.

Chakara:
  Assuming you are using DHCP to assign addresses to the phones, you need to use DHCP options to tell the phone what VLAN it should be a member of:

To use an external DHCP server you need the following options in your scope(s)
128 - The Ip address of the controller
129 - The IP address of the controller - again.
130 - String MITEL IP PHONE
132 - VLAN ID
133 - IP Priority (Mitel want it set to 6)

NewVoIP:
yes, we are using the dhcp from the 3300IPC, no external. Do we need to set this options still within the 3300IPC?

bobcheese:
Hi it depends on the setup.

The phone is only aware of Vlan tagging info it is given by a DHCP server. So it depends how you have setup the switch. If you are using fixed vlan ports for the phones (I.E the port is fixed to Vlan 30 no matter what is plugged in) then no Vlan info is needed by the phone as it doesnt need to 'tag' the packets with a Vlan ID as this is done at the switch. However if you are using the ports as 'dynamic' (I.E plugging a PC into the phone pass through and connecting to a different vlan then the DHCP server will need to inform the phone of the voice vlan. In this setup though you would either be using LDAP or 2 DHCP servers 1 in default Vlan & 1 in Voice Vlan.

Hope this helps.

NewVoIP:
We are configured for dynamic (pc connects to phone to the switch)
2 dhcp (MS Windows dhcp for data, default vlan), (3300IPC dhcp for phones, vlan 30)

Below is what is configured on the 3300IPC dhcp options.
  3  Router  172.168.30.1  IP Address 
  125  Mitel  id:ipphone.mitel.com;sw_tftp=172.168.30.2;call_srv=172.168.30.2;dscp=46v46s26  ASCII String
  128  TFTP Server  172.168.30.2  IP Address 
  129  Call Server  172.168.30.2  IP Address 
  130  IP Phone Identifier  MITEL IP PHONE  ASCII String
  134  DSCP  46  Numeric 

If i understand what you are suggestion, then would we need to include
132 = vlan30
133 = Ip Priority 6
Is this correct?

Navigation

[0] Message Index

[#] Next page