Mitel Forums > Mitel MiVoice Business/MCD/3300

Help 9.0.0.41 to 8.0.11.14 stuck on DB restore

<< < (2/2)

swilson:
This was a new controller with no real config in it yet.  It came with 9 and we are running 8.  At on point it was showing that both hard drives where in fault.  We are trying to manually reinstall right now.  I will post up the fix when we get it working.

Now I know never to do that again  :P

Stacey

Northeaster:
even if you do a manual install, it will fail if you try a restore, with a later version backup file.  So, do not do a restore.  Just program from scratch, as you said it doesn't have much info in the database anyway.

v2win:
If you have SDS just add it to the cluster and sync.

swilson:
I definitely don't plan on doing a restore again, I only checked it out of habit and we do not have SDS unfortunately(they are afraid to turn it on).  We finally got the hard drive faults to clear by clearing the RAID controller sockets and it is finally installing 8.  The steps are below in case anyone is interested.

To clear the sockets, perform the following steps.
1.   While power is OFF, verify both hard disks are removed.
2.   Turn the MXe power on. Wait until the fault LEDs on the RAID controller are orange.
3.   Turn the MXe power off. The RAID controller sockets are now clear.
4.   Proceed with the installation/upgrade.

Stacey

Navigation

[0] Message Index

[*] Previous page