Hi there Motel friends,
I have an issue with the LS trunks that the trunk takes like 3 ring (approx 10sec) before releasing the trunk.
For example when I dial into the system I get the MLAA that says. Welcome to company x, if you know your party extension you can dial it at any time. I will then dial the extension and the extension at the customer is ringing. I decide to hang-up because the person who I want to reach is not responding. When I close the connection the extension keeps ringing like 3 time before releasing the trunk.
The provider programmed line reversal on the line. I also programmed the line reversal on the circuit descriptor but it is not helping.
Here are my Circuitdiscriptor settings:
Number 1
Line Start Type Loop
Post Call Metering No
Guard Timer 800
Calling Party Disconnect No
Dictation Trunk No
Ignore Far End Disconnect No
Disconnect Timer 100
Ignore Far End Reversal During Seizure Yes
Ringing Expected Yes
Seize Timer 10
Address Signalling DTMF
Fake Answer Supervision After Outpulsing Yes
Ignore Answer Supervision Yes
Release Supervision Expected Yes
Audio Inhibit Until Answer Supervision Yes
High Loss Option No
Balance Network Setting National Complex
Trunk Category Short
Perform seize test on out-of-service trunks Yes
Ground Condition During Busy Out Removed
First Meter Pulse Is Answer No
Minimum Ring Detection Timer 200
Drop Digit Rcvr for Outgoing Audio Before Ans Sup No
Flash Timer 300
Call Clearing Signal Reversal
AC Impedance National
CLASS Trunk Yes
Milliwatt Tone
Silence Tone
Can someone help me out ?
Thanks in advanced.
Gimitel