Author Topic: E&M problems sending DTMF  (Read 2088 times)

Offline washo

  • New Member
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
E&M problems sending DTMF
« on: March 08, 2013, 05:01:45 PM »
Hi All,

I have an issue with a customer that has recently had their SX2K upgraded to an MXe but keeping the cabs etc.
The system uses back to back E&M trunks to send retrieve voicemail messages to a 3rd party voicemail/call logger server.
I have followed the same programming example that has been used in one of their other sites & the PDF guideline that shows all programming seems to be correct.

To access voicemail you dial 81
81 is an ARS route across the E&M trunks.
In the digit mode form there is programming that shows what call tone plan to use & also what digits to be inserted.

here I have programmed <T01><E>#
T01 is the tone plan to use (wait for tone is set to 2 seconds & out pulse is set to DTMF)
E is the symbol for the callers extn number to be sent
# is code for ending call/nothing to follow.

I have tested this on the 1st port of the 3rd parties server & I do not get an DTMF signal from the 3300/SX2K
All related programming has been checked & double checked but there is something somewhere that is stopping DTMF from being sent.

An ideas guys

Washo


Offline johnp

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2202
  • Country: us
  • Karma: +66/-0
    • View Profile
Re: E&M problems sending DTMF
« Reply #1 on: March 08, 2013, 09:37:34 PM »
Is the circuit descriptor set to DTMF or Loop?


 

Sitemap 1 2 3 4 5 6 7 8 9 10