Author Topic: Configuring an Polycom IP7000 conference phone to be connected to Mitel MXe 3300  (Read 15431 times)

Offline x-man

  • Hero Member
  • *****
  • Posts: 1129
  • Country: gb
  • Karma: +25/-0
    • View Profile
Also check that you have Max number in a conference set to 8 in system options (sounds like its set to 3).


Offline xrds

  • Jr. Member
  • **
  • Posts: 77
  • Karma: +0/-0
    • View Profile
Ralph

In System Options is what I have:

Max. CO Trunks In A Conference:  8
Max. Parties In A Conference:       8
Max. Trunks In A Conference:       8

Still doesn't work properly.

Could it be something in Class of Restriction Groups may be?

August, I have a dial plan in their, are you saying delete it save empty field and then go back in and put dial plan back?

Offline august

  • Sr. Member
  • ****
  • Posts: 258
  • Country: ca
  • Karma: +9/-0
    • View Profile
Just delete the dial plan (copy it in notepad or somewhere else).

Try it without a dial plan.  I'm pretty sure you have a problem with the  dial plan of the Polycom.

You will need to press # after you finish to dial your number if you don't want to wait for the digit to be outpulse.

Offline Mitel100

  • Sr. Member
  • ****
  • Posts: 262
  • Country: gb
  • Karma: +6/-0
    • View Profile
Polycom conference units do not support more than a 3 party conference. This is documented in the Polycom release notes.

Offline xrds

  • Jr. Member
  • **
  • Posts: 77
  • Karma: +0/-0
    • View Profile
It ended up being the Dial Plan in Web Utility of Polycom - had to change it several times before it worked.

Thanks for everyone's help, THAT was a BEAR!


 

Sitemap 1 2 3 4 5 6 7 8 9 10