Mitel Forums > Mitel MiVoice Business/MCD/3300

Interconnect restriction trough Sip trunk

<< < (3/4) > >>

ralph:
I'm seem to remember reading a "Known Issue" with interconnect failing on SIP calls.
I've been looking through the KPI docs but can't find it.  The link I had from Mitel (April 8) where I think I saw this no longer works. 
I'll keep looking.

Ralph

Mattmayn:

--- Quote ---From Interconnect Number --------- To Interconnect Number
1 - clear
2 - clear
3 - 2

--- End quote ---


This would allow calls from 2 to be made to 3, but not 3 to 2.

Check your sets to make sure that they have the correct interconnect assigned to the sets in the multiline ip set config form.

sadzas:

--- Quote from: Mattmayn on April 30, 2009, 08:56:34 AM ---
--- Quote ---From Interconnect Number --------- To Interconnect Number
1 - clear
2 - clear
3 - 2

--- End quote ---
This would allow calls from 2 to be made to 3, but not 3 to 2.

Check your sets to make sure that they have the correct interconnect assigned to the sets in the multiline ip set config form.

--- End quote ---
Yes, you're right, but it doesn't work! I can call from 3 to 2, that's what I saying.

I dont know what else can I do.

ralph:
As an experiment, take two phones.
Give them both an interconnect restriction of 10 (or whaterver)
Restrict 10 from 10.
Then tell me if you can call each other.

Also, take some screen shots of the extensions in the Change Attributes form for both extensions.
Then take a screenshot of the interconnect restriction table.

Post these screenshots online.

Ralph

sadzas:
Thanks Ralph for your help.

- Both phone InterCO: 10
- Restrict 10 to 10.
- Calls NORMALLY!!!

Interconnect Table


Ext. 150


Ext. 220

Navigation

[0] Message Index

[#] Next page

[*] Previous page