Author Topic: Polycom 8020 SIP Phones  (Read 1802 times)

Offline Ohiomtb

  • Contributer
  • *
  • Posts: 8
  • Karma: +0/-0
    • View Profile
Polycom 8020 SIP Phones
« on: November 27, 2012, 02:00:07 PM »
We have installed several Polycom 8020 phones on an MCD Ver. 5.0 SP1 and they are connected and working.  We are using WPP for QOS.  The Cisco AP's are 1250's.

The issue is when we use a phone in site survey mode the phones don't connect to all the access points that they should.  In checking things out some access points never are selected as the primary access point even when you are standing right below them.  Any suggestions as to what setting in the AP could cause this issue.


Offline Ohiomtb

  • Contributer
  • *
  • Posts: 8
  • Karma: +0/-0
    • View Profile
Re: Polycom 8020 SIP Phones
« Reply #1 on: November 27, 2012, 02:56:10 PM »
Sorry but we figured this out just after this message was posted.  Turned out to probably we a firmware issue with the Cisco AP.


 

Sitemap 1 2 3 4 5 6 7 8 9 10