Mitel 5320 is not getting IP address from DHCP

[vsha]

Hi,

MY CXi II controller is connected to another HP switch 2600 series and I made 17 port as turnk on my controller.  I have configure my DHCP server externally also and assign a static IP address to  both (Cxi II controller and  CXi II Switch ). Now the problem comes when i connect my phone on port 1 to 16  Cxi II inbuilt switch. My phones are unable to get IP address. The last message i see on phone screen is DHCP discovery only and phone version.  But if i connect my phone to my HP Switch POE port then the other phones are booting successfully.


Any Suggestion ...

Thanks in advance ..

[martyn]

Can you paste the config of the HP switch here? Also did you apply a vlan tag on the 3300 under the system IP form?

On a HP switch a port is a trunk by default, so you shouldn't have to configure a specific trunk as you do with a Cisco switch.

[vsha]

interface 23

-- MORE --, next page: Space, next line: Enter, quit: Control-C
   name "PABX_IP_Pad"
   no lacp
   no power
exit
interface 24
   name "PABX_CPU"
   speed-duplex 100-full
   no lacp
   no power
exit
interface 25
   name "****C"
exit
ip routing
vlan 1
   name "Data"
   untagged 1-12
   ip address 192.168.16.11 255.255.255.0
   tagged 25-26
   no untagged 13-24
   exit
vlan 7

-- MORE --, next page: Space, next line: Enter, quit: Control-C
   name "Voice"
   untagged 22-24
   ip address 192.168.17.11 255.255.255.0

   tagged 1-12,25-26
   exit
vlan 5
   name "Def-SV-Mitel"
   untagged 20-21
   ip address 192.168.0.11 255.255.255.0
   tagged 25-26
   exit
vlan 10
   name "Mitel-data"
   untagged 13-17
   ip address 192.168.110.11 255.255.255.0
   tagged 25-26
   exit
vlan 20
   name "Mitel-voice"
   untagged 18-19
   ip address 192.168.120.11 255.255.255.0
   tagged 13-17,25-26
   exit
qos type-of-service diff-services
ip route 0.0.0.0 0.0.0.0 192.168.16.1

[bobcheese]

so the PBX is connected to an untegged port on VLAN 7 (Voice) therefore so will all the 16 PoE ports on the front. Yet you have a Mitel Voice VLAN 20?? So I am guessing that a phone works when it is connected to a VLAN 20 port and then it routes to the PBX via whatever gateway is assigned by DHCP (as it seems PBX is on VLAN 7). So I would assume that your DHCP server is not servicing VLAN 7 and therefore when you plug into the front of CXI you get no DHCP. Try programming up a untagged VLAN 7 port on your HP switch and I bet you get the same issue.