Mitel Forums > Mitel MiVoice Business/MCD/3300

Oneway speech....

(1/2) > >>

tag:
Hi guys i have some issues on mitel 3300 ICP,R8.0,... Customer saying sometimes the calls are getting oneway speech.The system is configured ISDN-30 and its working fine,These issues are happens recently. So could you any one tell me what will be problem, why these alarm are recently happening?
I have post Maintence alarm...

tag,

tag:
any one konws these maintenance log...

tag

ralph:
I don't think any of these logs indicate a one way audio issue.
This first one indicates an FSK issue - (caller id on analog phones?  not sure)
One of the others did indicate packet loss, but that would be a poor quality issue.
Not sure about the Tuples log but I still don't think that is a one way quality issue.

Lets get a little more info here:   
What type of phone is making the call?
Is the call going out the same node it's registered to or out another 3300 accross an IP network?
What end of the call cannot hear?   The outside call or the inside call?

Ralph

steverowlands:
I had an issue with oneway voice on our IP phones not analogues phones

I flashed the IP sets and pointed the RTC & TFTP addresses to the IP address of the 3300 console. Below is a method I use to flash 5010 & 5020 IP phones:

Hold down up arrow and reset phone

Mattmayn:
Isn't there a maintenance command that will do this? Load Ip device all -something like that (helpful if you have many devices or do not have the ambition to walk to each device).

Navigation

[0] Message Index

[#] Next page