Mitel Forums > Mitel MiVoice Business/MCD/3300

definitive Shell command guide?

<< < (9/10) > >>

acejavelin:
Not really a guide, but something that isn't working... For a SIP IVR vendor I am supposed to enable early DPNSS ISDN messages (or something like that) which after enabling "Supress Simulated CCM before ISDN progress" in COS of TDM trunks I am supposed to go to the shell and enter"

CCS Enable DPNSS Early

But in the case of one system, MCD 6.0, it is not enabling but coming back with an unknown keyword. Any ideas?

petr.necas:
There is also "reboot" command for rebooting the 3300:

-> reboot

ralph:
From the SX2000 interface:

How do I restart SMDR (Station Message Detail Recording) without rebooting the controller?
 
If you're verified that SMDR is enabled in System Options and in the Classes of Service, run the following SX2000 commands:
2 - Pcb kill prog logsysspl
3 - Pcb kill prog logsysrtr
4 - Pcb kill prog logsysbfm

lundah:
mipsEnvShow - shows the properties of the L2/MIPS processor on the CX and MXe controllers
mips_reset - resets the L2/MIPS processor
period 900,mips_reset - resets the L2/MIPS every 900 seconds. This is useful if for some reason the L2/MIPS fails (I've had a run of several 50005090 vintage MXe's that do this after the controller loses power, only known fix is to replace the controller chassis). The period command could be used with other shell commands as well.

pmhaynes:
Restart web server
http://www.phonesystemhelp.info/2013/11/19/mcd-web-server/
Restart voicemail (useful instead of rebooting)
http://www.phonesystemhelp.info/2013/11/19/start-the-embedded-voicemail/
Restart TFTP server
http://www.phonesystemhelp.info/2013/11/20/mitel-tftp-server/

Navigation

[0] Message Index

[#] Next page

[*] Previous page